top of page
  • Writer's pictureRAZR Ice Augers

Late Summer Reminder: Replace Your RAZR Ice Auger Blades with This Easy Guide

Don't wait until winter to maintain your ice fishing gear! Learn how to replace the blades on your RAZR Ice Auger with this simple guide!

Factory Packaged RAZR Ice Auger Blades

As the summer months wind down, it's a good time to start thinking about preparing your ice fishing gear for the winter season. One important aspect of maintenance is replacing the blades on your RAZR Ice Auger.


With just an 8mm wrench and this easy-to-follow guide, you can replace the blades and ensure your auger is in top condition for your next ice fishing trip. Read on for step-by-step instructions on how to replace your RAZR Ice Auger blades.

  1. Begin by removing the blade cover and set the auger on a level surface like a work bench. Make sure the auger doesn't slip during this process.

  2. Using the 8mm wrench, loosen and remove the two bolts holding each blade in place.

  3. Take the old blades off and set them aside in a safe place.

  4. Take the new blades and place them onto the auger, making sure that the bolt holes line up with the holes on the auger.

  5. Insert the bolts and tighten them down with the 8mm wrench.

  6. Repeat this process for the other blade.

  7. Once both blades are in place and secure, replace the blade cover.

  8. Before using your auger, make sure to test it out to ensure that the blades are properly aligned and tightened.

By taking the time to replace your RAZR Ice Auger blades, you'll be ready for a successful and safe ice fishing season. Remember to keep an extra set of blades and an 8mm wrench in your ice fishing pack for easy replacements on the go. With proper maintenance and care, your RAZR Ice Auger will last for many winters to come.

Comments


bottom of page