top of page
  • Writer's pictureRAZR Ice Augers

How to Replace Blades on Your RAZR Ice Auger: Step-by-Step Guide

Learn how to replace the blades on your RAZR Ice Auger with this easy-to-follow guide.

Gussy drilling with a RAZR in Kenora, Ontario

If you want to keep your RAZR Ice Auger in top condition for your next ice fishing trip, replacing the blades is a simple process that can be done with just an 8mm wrench. In this step-by-step guide, we'll walk you through the process of replacing your RAZR Ice Auger blades.

  1. Begin by removing the blade cover and set the auger on a level surface like a work bench. Make sure the auger doesn't slip during this process.

  2. Using the 8mm wrench, loosen and remove the two bolts holding each blade in place.

  3. Take the old blades off and set them aside in a safe place.

  4. Take the new blades and place them onto the auger, making sure that the bolt holes line up with the holes on the auger.

  5. Insert the bolts and tighten them down with the 8mm wrench.

  6. Repeat this process for the other blade.

  7. Once both blades are in place and secure, replace the blade cover.

  8. Before using your auger, make sure to test it out to ensure that the blades are properly aligned and tightened.

By following these simple steps, you can replace the blades on your RAZR Ice Auger and keep it in top condition for your next ice fishing trip. Don't forget to always keep an 8mm wrench for blade replacements and an extra set of blades in your ice fishing pack!

Comments


bottom of page